Description
ABSTRACT
Use of renewable energy has been of great interest since last few years, especially the hydropower energy. Usually electricity is generated from hydropower energy, which is obtained from potential pressure heads, water discharge and hydro sites. Based on the location constraints, different types of hydro turbines can be designed and developed to generate electricity. The primary concern is to reduce the dependency on fossil fuels and increase the use of renewable power in rural areas. In this paper, designing of Kaplan turbine runner mechanism was discussed.
TABLE OF CONTENTS
COVER PAGE
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWELDGEMENT
ABSTRACT
CHAPTER ONE
1.0 INTRODUCTION
- BACKGROUND OF THE PROJECT
- AIM OF THE PROJECT
- SIGNIFICANCE OF THE PROJECT
- APPLICATIONS OF TURBINE RUNNER
- DISADVANTAGE OF KAPLAN TURBINE
CHAPTER TWO
LITERATURE REVIEW
- REVIEW OF THE STUDY
- HISTORICAL BACKGROUND OF HYDROPOWER GENERATION
- REVIEW OF PREVIOUS WORK ON KAPLAN TURBINE DESIGN AND OPTIMIZATION
- PROPOSED WORK
- CLASSIFICATION OF TURBINES
- TURBINES IN HYDROPOWER
- MAIN COMPONENTS OF KAPLAN TURBINE
- WORKING PRINCIPLE OF KAPLAN TURBINE
CHAPTER THREE
METHODOLOGY
- THEORETICALDESIGN
- TURBINE BLADEDESIGN
- COORDINATETRANSLATION
- DESIGNING OF THE GUIDE VANES
- CFD ANALYSIS
- CFD SOLVING SETUP
- LIMITATIONS
CHAPTER FOUR
- RESULT AND DISCUSSION
- OPTIMIZATION OF THE RUNNER WHEEL WITH CFD
- COMPARISON OF THEORETICAL AND CFD OPTIMIZED DESIGNS
CHAPTER FIVE
- CONCLUSION
- RECOMMENDATION
- REFERENCES
CHAPTER ONE
1.0 INTRODUCTION
1.1 BACKGROUND OF THE STUDY
Hydropower, generated mainly from hydroelectric dams, is a clear, green, and sustainable source of energy that produces cheaper electricity and lowers carbon emissions. Because of its high energy density, hydropower is the most efficient and most primarily available renewable power source to produce electricity [7]. In order to obtain greater efficiency, hydraulic turbines installed in the hydroelectric power plants have to be suitable, depending on the discharge of the site and head. There are a lot of hydraulic turbines available which are generally classified into two categories:
1] Impulse turbines
2] Reaction turbines
A hydraulic turbine in which all hydraulic energy of water gets converted into kinetic energy before the water reaches to the runner of the turbine is called impulse turbine. While in case of reaction turbine, some amount of available hydraulic energy is converted into kinetic energy before it strikes on the runner of the turbine. For flow head range available at the chosen site, reaction turbine is well suited. Reaction turbines include Propeller, Kaplan, and Francis turbine [2].
1.2 AIM OF THE PROJECT
There are different types of turbine runners or turbine blade, and all of them are made to achieve the same purpose of generating electricity in hydro-power plants. The main aim of this work is to design Kaplan type of turbine runner.
1.3 SIGNIFICANCE OF THE PROJECT
Turbine blade is the most widely used turbine in hydro-power plants to generate electricity. Mixed flow turbine is also used in irrigation water pumping sets to pump water from ground for irrigation. It is efficient over a wide range of water head and flow rate. It is most efficient hydro-turbine we have till date.
1.4 APPLICATIONS OF TURBINE RUNNER
- Kaplan turbines are widely used throughout the world for electrical power production.
- It can work more efficiently at low water head and high flow rates as compared with other types of turbines.
- It is smaller in size and easy to construct.
- The efficiency of Kaplan turbine is very high as compares with other hydraulic turbine.
1.5 DISADVANTAGE OF KAPLAN TURBINE
The only disadvantage of kaplan turbine is cavitation, which occurs due to pressure drop in draft tube. Use of draft tube and proper material generally stainless steel for the runner blades may reduce the cavitation problem to a greater extent.
Reviews
There are no reviews yet.