Description
ABRACT
This mains operated audio controlled running light can be used in discotheques. The lamps glow in running sequence as per the sound of music. Of the ten AC lamps, only one lamp permanently glows if there is no sound. When music is played, light starts ‘running’ through the lamps. The condenser mic converts audio signals into electric signals. Transistor T1 amplifies the microphone signals, which provide clock pulses to decade counter IC CD4017 (IC1). Preset VR1 is used to vary the signal level. The Q9 output provides reset signal to pin 15 of IC1. Divided-by-10 signals are fed to clock pin 14 of IC2, which is another decade counter. The outputs of IC2 drive transistors to provide triggering pulses to triacs. Triacs, in turn, drive the AC lamps.
TABLE OF CONTENTS
COVER PAGE
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWELDGEMENT
ABSTRACT
CHAPTER ONE
1.0 INTRODUCTION
1.1 BACKGROUND OF THE PROJECT
- PURPOSE OF THE PROJECT
- AIM OF THE PROJECT
- OBJECTIVE OF THE PROJECT
- PURPOSE OF THE PROJECT
- LIMITATION OF THE PROJECT
- ADVANTAGES OF THE PROJECT
- PROBLEM OF THE PROJECT
- APPLICATION OF THE PROJECT
- RESEARCH QUESTION
- PROJECT ORGANISATION
CHAPTER TWO
LITERATURE REVIEW
- OVERVIEW OF THE STUDY
- REVIEW OF THE RELATED STUDY
CHAPTER THREE
3.0 CONSTRUCTION METHODOLOGY
3.1 BASIC OF THE SYSTEM
3.2 BLOCK DIAGRAM OF THE SYSTEM
3.3 SYSTEM OPERATION
3.4 CIRCUIT DIAGRAM
3.5 CIRCUIT DESCRIPTION
3.6 DESCRIPTION OF COMPONENTS USED
3.7 POWER SUPPLY UNIT
CHAPTER FOUR
4.0 TESTING AND RESULTS
- CONSTRUCTION PROCEDURE AND TESTING
- INSTALLATION OF THE COMPLET DESIGN
- ASSEMBLING OF SECTIONS
- TESTING OF SYSTEM OPERATION
- COST ANALYSIS
CHAPTER FIVE
- CONCLUSION
- RECOMMENDATION
- REFERENCES
KEYWORD: audio controlled running light, sound controlled lights circuit, electronic circuits projects diagrams free, interesting electronic circuits, electronic circuit diagram, sound to light controller kit, music rhythm led flash light using microphone pdf, applications of music operated dancing leds, transistor projects
Audio Controlled Running Light Circuit
Fig. 1: Circuit for audio controlled running light
Fig. 1 shows the circuit for the audio controlled running light, while Fig. 2 shows the pin configuration of triac BT136.
The condenser mic converts audio signals into electric signals. Transistor T1 amplifies the microphone signals, which provide clock pulses to decade counter IC CD4017 (IC1). Preset VR1 is used to vary the signal level. The Q9 output provides reset signal to pin 15 of IC1. Divided-by-10 signals are fed to clock pin 14 of IC2, which is another decade counter. The outputs of IC2 drive transistors to provide triggering pulses to triacs. Triacs, in turn, drive the AC lamps. You can now see the lights running with the sound of the music.
Fig. 2: Pin configuration of triac BT136
Frequency-divider ICs CD4017 have been used here to reduce the audio to a noticeably low frequency. AC mains is rectified by diode D11, regulated by zener diode ZD1 and filtered by capacitor C4 to power the circuit.
Reviews
There are no reviews yet.